Spare Parts

Casing: The Cooling Tower Casing is made of FRP (Fibre Glass Reinforced Polyster). The FRP is a mats. Material is light in weight, Durable & Non Corrosive. An additional embossing is done for extra strength in case of big cooling towers. The cooling tower casing can resist/withstand wind velocities, vibrations and resistant to local impact.

PVC Files:

Suvidha offers a wide range of edge folded PVC Fill Products in honey comb design to mest your specific application, theses fills are optimally designed to achieve high surface area and offers minimum resistence to air flow providing more cooling by lower power consumption. They have uniform thickness throughout. Durable folded edges provide strength at critical locations on the fills

Motors:

Special (TEFC) Low RPM Motors foot mounted type with extended long shaft in IP: 55 weather proof construction are supplied to suit hot and humid atmosphere.

Fan:

Energy Efficient FRP Fans aerodynamically designed Aerofoil axial flow fans manufactured from high quality FRP material save up to 15 to 25% power as compared to other fans, and achieve the best performance keeping power consumption and noise levels to the minimum possible Aerodynamic axial flow FRP fans manufactured by SUVIDHA are specially designed for high-efficiency, cooling Tower

Nozzles:
The hot water is raised to the top and taken inside by a PVC Header, the header is further connected with branch pipes fitted with nozzles The performance of cooling tower greatly depend on the water distribution over the fills nozzles distribute water evenly through a wide spray angle without any drive pockets.

Eliminators:

Made of FRP/PVC, the eliminator is used to reduce water lasses due to entrainment of moisture drops in the air stream

Sprinkler:

Sprinkler is made of aluminium alloy to avoid corrosion & fitted with seal ball bearings to take care of thrust & radial loads it rotates at 5 to 12 RPM by the reaction force of circulating water. This water is discharge a set of Branch Pipes over the entire area of fill. Brass/ sprinkler be also be supplied on request of extra cost.

Header & Branch Pipe

These are used for the purpose of water distribution in Cooling Tower.

Supporting Structures

All Supporting Steel Structures are hot dip Galvanized,